Clean Green Energy Blog

Homemade Wood Boiler

A homemade wood boiler is one of the best ways for home heating purposes. The water is usually piped through the radiator of a car, which is installed in the cold air return of a furnace that is standard. The furnace is shut off at this point, the thermostat is supposed to turn the fan on so that the air that is warmed by the radiator can be drawn to heat the house through the duct of the home. The best thing about these wood boilers is that they can be used to heat water for the heating of the under floor.

The Boiler

The homemade wood boiler is a simple device that has two pieces of steel that are rolled out and they are welded together. The big one is usually on the outside and the small one on the inside, which makes them form an inner sleeve that contains the wood fire. The water that is supposed to be heated is usually held by the area between the inner sleeve and the outside steel.

The boiler is designed in such a way that it looks like a barrel stove but it is usually smaller on the inside than the stove. The amount of water intakes and outlets usually varies depending on the use. Cold water usually enters through the bottom of the boiler  while warm water leaves through the top of the boiler and one should ensure that they install a valve for relieving the pressure so that they can be safe when using the boiler. This is usually an easy thing to construct and it offers a lot of benefits owing to the fact that it is not expensive and it helps one a lot.

The Pump

A pump is usually needed so that it can help in the circulation of the water through the heating system. The size of the pump depends on the amount of water being used and also the distance that the water is required to move from one point to the other. In this regard, a one horse power pump is considered because it does not need much force but if you are going to move large amounts of water then it is advisable to for a stronger motor.

Regulation of the Boiler

There are a number of options that are available for the water temperature regulations and they all require a thermometer in order to measure the water temperature in the boiler. However, the simplest way of regulating is doing it manually in order to control the amount of heat produced in the firebox.

Ensure that you regulate it appropriately depending on the temperature of the water. You can also install a barometric draft regulator if you do not want to do it manually. This regulator will make sure that the damper is adjusted so that the temperature of the water can be maintained. This homemade wood boiler is something that can be of great help to the household especially during the cold seasons since it does not require a lot of money to own one.